1.10.2 Fill Spa With Water Power Up Spa and Set Water Temperature

 

The following steps provide guidance to help establish correct chemically balanced water. To help ensure chemicals dissolve appropriately it is good practice to first mix/dissolve the chemical in an uncontaminated container of hot water before carefully adding to the spa water.

Note: The following steps take into account that the Spa Technician has filled your spa with water to above the Spa Boy Sensor Housing, removed the Spa Boy Sensor Plug, installed the Spa Boy Sensor Housing Grate and installed the Spa Boy Sensor.

Warning: Do not proceed until the Spa Technician has filled your spa with water to above the Spa Boy Sensor Housing, removed the Spa Boy Housing Plug, installed the Spa Boy Sensor Housing Grate and installed the Spa Boy Sensor or you have obtained further direction from your Dealer.

Spa Boy Owners Manual

Steps to Fill Spa With Water Power Up Spa and Set Water Temperature

Filling the spa through the filter

Step 1. Fill Spa

Fill your spa through the filter intake as shown to the appropriate level (just under the head rests). If you have sediment or high mineral content a “carbon filled pre-filter”, as pictured, can help. (This is optional and will prolong the fill time).

Connect/Turn On Electrical Power To The Spa

Step 2. Connect/Turn On Electrical Power To The Spa

Once the spa is filled to the proper level, connect power to the spa in accordance with the Arctic Spas Owners Manual, and turn the power on to the spa on.

 Topside Controller

Step 3. Set Water Temperature

Set the water temperature control on the Topside Controller to the desired temperature (between 100ºF and 104ºF or 38°C and 40°C).