Water Temperature Regulation
In a regulation cycle, the system first generates water flow through the heater housing and the plumbing, in order to ensure accurate water temperature readings as well as avoiding heater activation in dry conditions.
After verifying pump activation and taking a water temperature reading if required, the system automatically turns the heater on to reach and maintain water temperature at Set Point.
|The “Heater” indicator lights up when the heater is on. It flashes when there is a request for more heat but the heater has not yet started.|
Smart Winter Mode
Our Smart Winter Mode protects your system from the cold by turning pumps on several times a day to prevent water from freezing in pipes.
|The “Smart Winter Mode” indicator lights up when the Smart Winter Mode is on.|
While performing this task, the heater is not allowed to turn on and its icon flashes.
Press Light Key to turn lights on. A second press turns lights off. A built-in timer automatically turns light off after 2 hours, unless it has been manually deactivated first.
The “Light” indicator lights up when light is on
Up / Down Keys
Use Up or Down key to set desired water temperature. The temperature setting will be displayed for 2 seconds to confirm your new selection.
2 pump spas have a combined Up/Down Key. Hold the button to increase the parameter and release the button to stop. Hold the button again to decrease the parameter.
|The “Set Point” icon indicates that the display shows the desired temperature, NOT the current water temperature!|
Press Light Key to turn lights on. A second press turns lights off. The program menu is accessible by holding down the Light key for 5 seconds. In the program menu the following parameters can be set: clock, filter or purge cycles, economy mode and temperature units. While in the program menu, use the Up or Down key to adjust the parameters and use the Light key to jump to the next parameter. The changes will be saved after the confirmation of the last parameter only. If there is no action taken for 10 seconds, the system will exit the program menu without saving any changes.
Setting the Clock
Enter the program menu by holding down the Light key for 5 seconds. The display will show the current clock setting with the hour flashing.
Depending on factory settings your system may be set to 24-hour time or 12-hour time.
Setting the hour: Use the arrow keys to adjust the hour. Press the Light key to jump to the next parameter, the minutes. Setting the minutes: Use the arrow keys to adjust the minutes. Press the Light key to jump to the next parameter, the filter or purge start time (FS).
Programming the filter
The filter cycle menu consists of the following parameters: the start time (FS), the duration (Fd) and the frequency (FF). A filter cycle consists of starting all the pumps in high speed for 1 minute (purge step) then, the pump associated with the filter will run in low speed for the remaining duration of the filter cycle (clean step).